Vintage and Veteran Products

There are two sizes of gaskets required for the 3 1/4 inch Pre-WW1 Davison sight glass. A 31mm OD gasket to fit in the top cap and a 29mm OD gasket to fit on the base of the glass. One top gasket and one base gasket should be installed. In the kit there are 2x 2mm and 3mm thick gaskets (4 gaskets in total)

AJS type, 80mm ID, Crushable Copper cylinder head gasket for 350cc AJS vintage motorcycles
Traditional copper sandwich construction with asbestos substitute material inside.
Ensure that you receive a copy of the recommended Installation Procedures from ourselves. For the installation a small amount of high -temperature -grease is recommended.

AJS type, 92mm ID, Crushable Copper cylinder head gasket for 500cc AJS vintage motorcycles. Traditional copper sandwich construction with asbestos substitute material inside. Ensure that you receive a copy of the recommended Installation Procedures from ourselves. For the installation a small amount of high temperature grease is required.

Part Nr 62-462 Enots dome oil sight glass base Gasket This gasket sits under the base of an Enots dome oil sight glass. There is a 2mm thick neoprene impregnated cork gasket and a 3mm thick gasket in the kit to cope with various thread lengths on the pumps over the decades . In unusual cases where a 4mm thick gasket is required consider purchasing two kits and place a 2mm gasket on top of another 2 mm gasket to achieve 4mm . Please read the secondary information below regarding estimating the thickness required.

BSA Fuel/Oil/cap gaskets 51.15mm OD X 40.90mm ID 1mm thick. There are two individual gaskets for 2 caps plus a third gasket with which to practice the installation.
In addition there are two small tubes of a suitable adhesive. Ensure you request us to email you a copy of the recommended installation procedure

1+3/8-inch X 1+5/8- inch Crushable Copper gaskets with asbestos substitute material inside. The typical Imperial size for your Douglas motorcycle valve port gaskets